20220220

GUI

• Fixed data verification not being performed after partial writes to partially protected EEPROMs
• Fixed incorrect "multiple EEPROMs" warning message when checking RSWP on serial device
• Fixed crash that occurred when checking RSWP on serial device
• Added detailed SMBus info under Device>Info menu
• Added option to connect to SMBus on startup
• Added human-friendly SMBus naming

20220208

GUI

• Fixed reading from serial device returning invalid data due to broken address setting
• Fixed write protection not being checked before writing on X299
• Fixed retry button not working upon write error
• Added option to disable RGB warning
• Improved X299 RSWP detection
• Improved SMBus detection

20220202

GUI

• Added support to read and write system DDR4 RAM SPDs on Intel X299 platforms
  For more info, see https://forums.evga.com/FindPost/3524546

20211228

GUI

• Fixed port not being released after failed connection

Firmware

• Improved connection compatibility

20211208

GUI

• Includes FW 20211208

Firmware

• Fixed SA1 control

20211206

GUI

• Check RSWP and Set RSWP windows properly centered for all supported RAM types
• Check RSWP and Set RSWP windows standardized for all supported RAM types
• Improved automatic EEPROM SPD size detection
• Added dialog box result after PSWP operation
• Removed redundant "Set RAM type" option

Firmware

• Enforced hardware support
• Improved RSWP support
• Improved PSWP support
• Improved pin controls

20211202

GUI

• Includes updated firmware (see below)

Firmware

• Updated Read RSWP in compliance with Jedec EE1002(A) and TSE2002av definitions

20211201

GUI

• Fixed CRC status appearing when SPD data is not loaded
• Improved performance

Firmware

• Fixed restore defaults command not resetting I2C clock settings
• Fixed DDR4 detection compatibility
• Improved RSWP reliability

20211119

GUI

• Fixed some option items not highlighting in settings window after being edited
• Fixed some groupboxes not resizing when settings window is resized
• Fixed incorrect I2C clock reporting upon initial connection
• Added part number identification for all RAM types
• Integrated firmware (Help > Firmware update...)

Firmware

• Added factory reset settings command

20211111

GUI

• Cleaned up connection options in program settings window
• Reorganized interface options in program settings window
• Added manual connection baud rate option
• Improved manual connection performance
• Improved hot plugging support
• Added I2C fast mode option

Firmware

• Added option to specify I2C clock
• Improved SA1 test reliability