Skip to content

Latest commit

 

History

History
65 lines (42 loc) · 2.5 KB

README.md

File metadata and controls

65 lines (42 loc) · 2.5 KB

meta-sunxi

Official sunxi OpenEmbedded layer for Allwinner-based boards.

This layer depends on the additional layer:

meta-openembedded: git://git.openembedded.org/meta-openembedded

Tested with core-image-base.

Maintainers:

Kernel / U-Boot Version

Most Allwinner devices and hardware are supported in mainline kernel and U-Boot, so this layer builds mainline by default. There is a custom U-Boot and Kernel version for sunxi devices which includes some special drivers not mainlined. These versions are rather old (3.4 for kernel and 2014.04 for U-Boot), but may support more functions and devices than current mainline

If you want to switch back to sunxi versions for some reasons (no device tree available, unsupported hardware), either:

  • change the file conf/machine/include/sunxi.inc to include the following block

  • edit your conf/local.conf to add the following block

    PREFERRED_PROVIDER_u-boot="u-boot-sunxi" PREFERRED_PROVIDER_virtual/bootloader="u-boot-sunxi" PREFERRED_PROVIDER_virtual/kernel="linux-sunxi"

If you already have built the mainline versions it might be necessary to reset the build directories with:

bitbake -c clean linux u-boot

Performance

The default machine settings are meant to be the lowest common denominator, maximizing generality. Significantly better performance (2x-3x) can be achieved with the following settings:

Allwinner A20

For Allwinner A20 (Cubieboard2/CubieTruck), the following tuning options are recommended:

Enable hardfloat, thumb2 and neon capabilities

DEFAULTTUNE = "cortexa7hf-neon-vfpv4"

This tuning profile takes advantage of the Allwinner A20 hardfloat, neon and vfpv4 capabilities.

Change CPU governor to ondemand, and tune settings

echo ondemand > /sys/devices/system/cpu/cpu0/cpufreq/scaling_governor
echo 336000 > /sys/devices/system/cpu/cpu0/cpufreq/scaling_min_freq
echo 912000 > /sys/devices/system/cpu/cpu0/cpufreq/scaling_max_freq
#More aggressive
#echo 1008000 > /sys/devices/system/cpu/cpu0/cpufreq/scaling_max_freq
echo 40 > /sys/devices/system/cpu/cpufreq/ondemand/up_threshold
echo 200000 > /sys/devices/system/cpu/cpufreq/ondemand/sampling_rate

This code changes the default CPU governor from fantasy to ondemand, and tunes its settings, as recommended at http://linux-sunxi.org/Cpufreq

For additional discussion, see linux-sunxi#25